Hot Selling Laboratory Hydrothermal Synthesis Autoclave Reactor With PTFE Chamber
Introduction:
hydrothermal synthesis reactor is the reactor that provides synthetic chemical substances in certain temperature and pressure conditions.
Features:
1. It is made of quality non-magnetic0Cr18Ni9Ti of stainless steel.
2. The kettle body and kettle cover are sealed by durable and reliable line seal structure with long-term stability to leak free seal.
3. Stainless steel chassis, stainless steel kettle body, stainless steel gland, stainless steel kettle cover and extended stainless steel rods.
4. With PTFE liner, double care, acid and alkali, resistant to high temperature of 200ºC
5. Thickening processing PTFE cover, not easy to soften.
6. Beautiful appearance, reasonable structure and easy to operate.
7. Good corrosion resistance.
| Model |
KH-25 |
KH-50 |
KH-100 |
KH-150 |
KH-200 |
KH-250 |
KH-300 |
KH-500 |
KH-1000 |
| Volume |
25ml |
50ml |
100ml |
150ml |
200ml |
250ml |
300ml |
500ml |
1000ml |
| Material |
SS304 Stainless Steel Kettle; PTFE/PPL Liner |
| Pressure |
≤3Mpa |
| Temp. Range |
PTFE≤240ºC PPL≤300ºC (Highest Temperature) |
| Heating or Cooling Rate |
≤5ºC/Min |
| Remarks |
Advancing working temp: 220ºC(PTFE), 280ºC (PPL); The highest pressure is 3Mpa.
|
Operation Steps:
1.Pour the reaction solvent into the PTFE/PPL liner and ensure the freaction solvent is less than 80% of volume.
2. Make sure that the bottom gasket of reactor is in the correct position (protrusion facing down), then place the PTEF/PPL liner and upper gasket, and tighten the kettle lid with a screw.
3. The hydrothermal synthesis reactor is placed in a heater and heated to a desired temperature (less than the specified safe use temperature) according to the specified temperature increase rate.
4. The kettle lid could be opened when you confirm that the temperature in the kettle is lower than the boiling point of the reaction solvent. When the temperature is to be cooled at the end of the reaction, it must be operated strictly in accordance with the specified cooling rate to facilitate safety and the service life of the reactor.
5. After confirming that the temperature in the reactor is lower than the boiling point of the reaction solvent, please loosen the kettle lid with a screw, and then open the kettle lid.
6. The hydrothermal synthesis reactor should be cleaned in time after use to avoid rust. The Sealing part of kettle and kettle lid should be carefully cleaned and protected from damage.
Our Services:
Audited Supplier 
){kind=link}